PDA

View Full Version : Experienced Modder Needed - HELP


just strum
January 11th, 2009, 05:28 PM
http://i60.photobucket.com/albums/h16/auroraohio/Smiley/SM030.gif

on the attached it shows the red and white wires taped or secured together - do you know if they should be stripped at the end or left with casing on???

http://www.seymourduncan.com/pdfs/support/schematics/2h_2v_2t_3w.pdf
tunghaichuan
January 11th, 2009, 05:29 PM
Strip the wires, solder them together and insulate them. They need to be connected to complete the circuit.

tung




http://i60.photobucket.com/albums/h16/auroraohio/Smiley/SM030.gif

on the attached it shows the red and white wires taped or secured together - do you know if they should be stripped at the end or left with casing on???

http://www.seymourduncan.com/pdfs/support/schematics/2h_2v_2t_3w.pdf
mrmudcat
January 11th, 2009, 05:34 PM
Yea what he said. They can also be shrinked wrap after soldering together or just electrical tape:beer:
just strum
January 11th, 2009, 05:35 PM
whew, that's what I did on the bridge pup and then started second guessing myself. Thanks for the quick response.
tunghaichuan
January 11th, 2009, 05:38 PM
Yea what he said. They can also be shrinked wrap after soldering together or just electrical tape:beer:

Electrical tape works in a pinch, but I personally hate the stuff. It always gets nasty sticky residue on anything it is wrapped around. Heat shrink is much better for guitar electronics. Just sayin' :D Rat Shack used to sell a package of heat shrink. Not great, but better than electrical tape.

tung
mrmudcat
January 11th, 2009, 06:01 PM
I agree I shrink wrap as ive been doing on puters or guitars.:rotflmao: