Voo - your wish is my command!


Justa - I did the same thing that you mentioned. I used a piece of 1x2 on the top to raise it some from the floor. This board is 1x12 pine and is 36 inches long. I'm not taking it anywhere either so I didn't care about portability. I like having my pedals in line with each other instead of staggered. I get way better signal from the short patch cables. I also took off the little power strip from the old board and attached it to the top of this one so that I'd have even more connections. I run most of the pedals off the TU-2 and I use the old strip for my 1/8" mini connectors (the MXR Micro Amp). I could still put more pedals on there if I wanted to but I still don't want to stagger.

Attachment 1152

I run a 1 foot patch cable from the looper to the FS-5U switch but it's not there in the photo. Again I attached the pedals to the board with a simple eye hooks and cloth covered rubber band system. Easier for me to disconnect the pedals and they stay on the board without coming off as they did with velcro. I thought about covering the board with some of that material that you talked about Justa but I remember that my other board with the fuzzy velcro material used to get wicked dusty and would stick to the fuzz real bad...that's why I just spray painted it black. Easy to dust off.