Tube Screamer Clone Mod

[ted s]

Looking good DVM, but, uhm.. where is the Mojo dial ?

[duhvoodooman***]

...where is the Mojo dial ?

Well, since there's a chance I might actually try to sell a few of these, I figured that the prototype should probably stick with the usual Level-Drive-Tone designations that people are familiar with on overdrive pedals. But fear not--the mojo is INSIDE!!

[oldguy]

So...if you actually sell some of these things...
Can I get one with a low serial #, just in case?

[tot_Ou_tard]

Well, since there's a chance I might actually try to sell a few of these, I figured that the prototype should probably stick with the usual Level-Drive-Tone designations that people are familiar with on overdrive pedals. But fear not--the mojo is INSIDE!!

I think you'd sell more with a mojo dial, but what do I know?

[F_BSurfer]

Awesome looking pedal DVM and can't leave out great sounding If I didn't already have a modded boss Sd-1 I would be on board for one of these You do have me remodding though already changed tone pot out The boss had a 20k and flattin out between 10 and 1 excellent now with the 2K Now will do my homework and change the two position switch for the three and incorperate the Led Like you said op amp chip changes are kind of minor I have had RC4558P, RC4559P, JRC4558D and Burr Brown OPA2134PA the brown to me makes the pedal more transparent and adds clarity which to me benifits single coil pickup and the splitting of humbucker

[duhvoodooman***]

All done after 3 coats of clear lacquer:

[Spudman***]

That is too pretty to play. The first one should go in the display case. Awesome job. (toast to Voodoo)

[oldguy]

Really nice, DVM! You definately have a talent for this, and your attention to detail shows. Kudos to DuhVoodooMan !

Hey, DVM, did you get my PMs ?