Next step: getting the chassis ready for the face plates.

I received all the parts I needed to finish the project yesterday. The next step is to generate the face plate and back plate files. With the 13" long by 2" wide chassis, it is possible to print out 1:1 face plates to make sure the controls are in the right place and are labeled correctly.

http://www.diycustomamps.com/images/...chassis_31.jpg
http://www.diycustomamps.com/images/...chassis_32.jpg
http://www.diycustomamps.com/images/...chassis_33.jpg
http://www.diycustomamps.com/images/...chassis_34.jpg
http://www.diycustomamps.com/images/...chassis_35.jpg
http://www.diycustomamps.com/images/...chassis_36.jpg
http://www.diycustomamps.com/images/...chassis_37.jpg

After some minor editing, I believe the face & back plates are ready to send off to BNP Lasers. I'm going to go with black plastic with white writing for a Hiwatt vibe. I won't drill any holes for the controls until both plates arrive at my house.

Stay tuned...

tung