Got the ART Tube MP Studio today and have opened it up to have a look around. The plate current of the 12AX7 operating with just 48 volts on its plate is only 65uA with R61 a feedback resistor removed. There is approx 5uA of grid current so with the 20k grid resistor the grid is -0.1 volt and with a 2k cathode resistor the cathode voltage is 0.129 volts. The gain of the tube is approx 40. The second triode in the tube is used as a cathode follower. Figure I will cut traces on the PCB connect an emitter follower to the first triode plate for a high impedance to low impedance buffer. Then make a common cathode stage out of the second triode. With the high grid current the grid resistor values used will need to be 50k or less can probably grid bias the tube with the cathode tied to ground. So if I get a gain of 40 from each tube should have an overall tube gain of 1600.